The Slide-Diver Lite Bite uses the properties of a diver disk to take lures down and away from the boat, but allows the angler to stretch the offering well behind the diver, which instantly releases at the lightest bite from a fish.

"We like to say that as soon as your rod moves, all you have to do is remove it from the rod holder and reel", says company president and Slide Diver inventor Randy Even, a charter captain out of Sheboygan, Wisconsin. "Basically, it's like having a tacklebox downrigger-put one on either side of the boat and you have two more precise depth control devices that allow you to set lines as deep below and as far behind the boat as you want."

The Slide Diver Lite-Bite, like the original Slide Diver, has a mechanism that allows it to be clamped down anywhere on the fishing line. What sets the Lite Bite apart is an extra "arm" that instantly pries the release mechanism open when a fish of any size hits. Properly adjusted, the Lite-Bite can handle everything from the smallest spoons and walleye spinner rigs to the largest flashers and cut herring set-ups. Even noted that anglers who troll for virtually any species, from crappie and walleye to salmon and striped bass will benefit from the new disk.

"We've been testing this design for more than two years and feel it's right where we want it to be to work perfectly every time," says Even. "The days of towing a small fish around behind a diver without knowing it are gone for good."

---

Hi Guys

Let me start by saying that the more I fish with the Lite Bite Slide Diver the more I like it. In the past fishing Champlain with a Dipsey could be very frustrating. A traditional Dipsey would drag small fish for hours without you knowing it. I do not know how many times I have pulled in a dipsey to find a small perch or Salmon or Laker that did not release the Dipsey. This will not happen with a Light Bite Slide Diver. Check out the Pic! This is just one of the many reasons this new tool will be a great weapon on Champlain. There is a learning curve to fishing this tool. You have to thread your line through an assembly and a bead and keep them on the rod when not in use. We have been using 20# braid, this helps with delivery and is stronger. A bad nick in mono and you could lose it! These are not inexpensive but much cheaper than a downrigger. Being able to put out as much line as you want is an awesome benefit. We have been running about 40 to 60 ft behind the diver, engage the diver, dial in the setting, put out to desired depth and catch fish. It sure was fun to watch the rod almost rip off the side of the boat when bills Salmon hit, a much different experience from watching a downrigger release. After using these for a couple of weeks I am hooked. Feel free to ask questions.

Good Luck
Thorny